How to Display Your Possessed Lamb Keychain and Indie Pins

By Youtooz Collectibles | Published: 2026-11-01

Category: How-to Guides

Build a pin-and-keychain display board that keeps your Possessed Lamb Keychain and indie enamel pins visible, secure, and free from scratches.

Quick answer

Mount a fabric-covered board at eye level, hang the Possessed Lamb Keychain from a dedicated hook so its 5-inch plush body hangs free, and pin indie enamel pins at least an inch apart to prevent metal-on-metal scratches.

Why a shared board works for plush keychains and enamel pins

A single board keeps small indie collectibles visible without crowding a shelf, but plush keychains and enamel pins have different needs. The 5-inch Possessed Lamb Keychain is soft and filled with 100% PP cotton, so it needs vertical clearance and a hook that won't compress its wool. Enamel pins are rigid and scratch easily when they touch each other. Plan separate zones on the same board: a hanging zone for keychains and a flat zone for pins.

Choose a board material that protects enamel and fabric

Cork and fabric-covered boards are good for pins because they grip the post without forcing it. Avoid bare metal or glass backings, which can chip enamel if a pin shifts. For the keychain, a wooden or fabric board with a small screw hook works better than a pushpin, which can leave a hole in the plush. If you rent and can't drill, use a adhesive-backed hook rated for light weight, but test it for 24 hours before hanging anything.

When to use two separate displays instead

If your collection is growing, a single board can become crowded and make it hard to remove one item without disturbing others. A small pin banner for enamel pins and a single hook for the keychain keeps each piece accessible. This also helps if you want to rotate keychains seasonally without unpinning a whole board.

Steps to set up your pin and keychain display board

Pick and prepare the board: Choose a fabric-covered cork board or a framed fabric panel at least 12 by 16 inches. Wipe it with a dry cloth and let it dry fully before mounting. Checkpoint: the board should be dry and free of dust so adhesive hooks and pins hold firmly.
Mark the keychain zone: Set aside one upper corner for the Possessed Lamb Keychain. Measure 6 inches down from the top edge and mark where the hook will go. Mistake to avoid: placing the hook too low so the 5-inch plush rests on the board or a pin below.
Install the hook: Screw in a small cup hook or attach an adhesive hook rated for light weight. If using adhesive, press firmly for 30 seconds and wait 24 hours before hanging. Checkpoint: tug gently on the hook before hanging the keychain to confirm it is secure.
Hang the keychain: Clip the keyring onto the hook so the plush hangs freely. Adjust the chain so the Lamb's face and crown are visible and not twisted. Checkpoint: the keychain should not touch the board or any pin.
Lay out the pins: Arrange enamel pins in the remaining space, leaving at least 1 inch between each pin. Push each post into the board until the back is snug, then secure the clutch. Mistake to avoid: forcing a pin into a hard board, which can bend the post or chip the enamel.
Check stability and adjust: Step back and look for overcrowding or sagging. If the board feels loose, add a second mounting point. Recheck adhesive hooks monthly. Checkpoint: nothing should overlap or hang below the board's bottom edge.

Product facts

Possessed Lamb Keychain (5in): The Possessed Lamb Keychain stands 5 inches tall and is packed with 100% PP cotton. Its size means you need at least 6 inches of vertical clearance below the hook so the plush hangs without resting on the board.
Possessed Lamb Keychain (5in)